Thursday, October 08, 2009

GAO Reports On Mercury Controls At Coal-Fired Power Plants

Oct 8: The Government Accountability Office (GAO) released a report entitled, Clean Air Act: Mercury Control Technologies at Coal-Fired Power Plants Have Achieved Substantial Emissions Reductions (GAO-10-47, October 8, 2009). The report was prepared at the request of Senator Thomas Carper (D-DE) who serves as the Chairman of the Subcommittee on Clean Air and Nuclear Safety under the Committee on Environment and Public Works.

GAO indicates that the 491 U.S. coal-fired power plants are the largest unregulated industrial source of mercury emissions nationwide, annually emitting about 48 tons of mercury -- a toxic element that poses health threats, including neurological disorders in children. In 2000, U.S. EPA determined that mercury emissions from these sources should be regulated, but the Agency has not set a maximum achievable control technology (MACT) standard, as the Clean Air Act requires. Some power plants, however, must reduce mercury emissions to comply with state regulations or consent decrees.

After managing a long-term mercury control research and development program, the Department of Energy (DOE) reported in 2008 that systems that inject sorbents -- powdery substances to which mercury binds -- into the exhaust from boilers of coal-fired power plants were ready for commercial deployment. Tests of sorbent injection systems, the most mature mercury control technology, were conducted on a variety of coal types and boiler configurations -- that is, on boilers using different air pollution control devices. In this context, GAO was asked to examine (1) reductions achieved by mercury control technologies and the extent of their use at power plants; (2) the cost of mercury control technologies; and, (3) key issues EPA faces in regulating mercury emissions from power plants. GAO obtained data from power plants operating sorbent injection systems.

GAO reports that commercial deployments and 50 DOE and industry tests of sorbent injection systems have achieved, on average, 90 percent reductions in mercury emissions. These systems are being used on 25 boilers at 14 coal-fired plants, enabling them to meet state or other mercury emission requirements -- generally 80 percent to 90 percent reductions. Importantly, the substantial mercury reductions using these systems commercially and in tests were achieved with all three main types of coal and on boiler configurations that exist at nearly three-fourths of U.S. coal-fired power plants.

The cost of the mercury control technologies in use at power plants has varied, depending in large part on decisions regarding compliance with other pollution reduction requirements. The costs of purchasing and installing sorbent injection systems and monitoring equipment have averaged about $3.6 million for the 14 coal-fired boilers operating sorbent systems alone to meet state requirements. The cost is a fraction of the cost of other pollution control devices. When plants also installed a fabric filter device primarily to assist the sorbent injection system in mercury reduction, the average cost of $16 million is still relatively low compared with that of other air pollution control devices. Annual operating costs of sorbent injection systems, which often consist almost entirely of the cost of the sorbent itself, have been, on average, about $675,000. In addition, some plants have incurred other costs, primarily due to lost sales of a coal combustion byproduct -- fly ash -- that plants have sold for commercial use. The carbon in sorbents can render fly ash unusable for certain purposes.

EPA’s decisions on key regulatory issues will have implications for the effectiveness of its mercury emissions standard. In particular, the data EPA decides to use will impact: (1) the emissions reductions it starts with in developing its regulation; (2) whether it will establish varying standards for the three main coal types; and, (3) how the standard will take into account a full range of operating conditions at the plants. These issues can affect the stringency of the MACT standard EPA proposes. For example, if EPA uses data from its 1999 power plant survey as the basis for its mercury standard, the standard could be less stringent than what has been broadly demonstrated in recent commercial deployments and DOE tests of sorbent injection systems at power plants. On July 2, 2009, EPA announced that it would seek approval from the Office of Management and Budget to conduct an information collection request to update existing emissions data, among other things, from power plants.

Access the complete 47-page GAO report (
click here).